MICRESS Forum

Dear Bernd,

I tried the simulations after applying Stoichiometric conditions.
However, I still have the same Error.
The phase Al3X is not present in the Mobility database of the GES file, Could this also be a reason for this error?

.
.

Dear Bernd, Greetings for the day :) . Thank you very much for your quick reply. I have applied your suggestions to the simulation regarding the 'Initial microstructure' and also in the 'Nucleation' section. and have used Nucleation distance input instead of the shield distance. I have got the follo...

Dear All, Good day. I am working on the solidification simulation of Al-Mg alloy in LPBF and then want to make a comparison of the simulation microstructure with EBSD results. I have selected the phases and their interactions based on the Scheil diagram (FIGURE A). For #Process_conditions I have use...

Dear Bernd, Thank you for your quick response and the answers. I have applied the suggested solutions. However, towards the end of the simulation, some error messages were displayed. How do I correct these? Thank you. Error message.jpg Columnar results.png Thank you and Best Regards, Desai. NEW FEB ...

Dear All, Good day. I have been working on the solidification of an alloy (Al-Mg-Zr) by LPBF process. For simulating the growth of columnar grains, a thermal gradient of 1x10^5 K/cm and a cooling rate of 1x10^6 K/s was applied. I have used the mobility database MOBAL5 along with TCAL7. The following...