MICRESS Forum

Hi, Bernd,

I found some errors on the screen (see the attached figure) when I running the program. I used the thermodynamic database in my simulation. And the diffusion coefficients were entered and assumed as composition-independent. Although this error exists, the program continues, but I do not know whether it will affect the final results.

Could you tell me how to avoid this error?

Thank you in advance!


Sincerely yours,

Sunny

Hi sunny,

If these errors you show are the only ones which occur, this most probably is not affecting the results. Typically, if MICRESS runs into serious trouble, a big number of such messages appear and the program gets very slow. Then you should also see traces of that in the output files (.conc*, .driv).

Bernd

Hi, Bernd,

Thank you very much for your reply!

Sunny