Discuss

aspects of evaluating simulation results and their graphic presentation using either DisplayMICRESS or other software tools. Features and possibilities of DisplayMICRESS
Post Reply
1Tap
Posts: 1
Joined: Sat Sep 14, 2019 9:17 pm
anti_bot: 333

Discuss

Post by 1Tap » Sat Sep 14, 2019 9:20 pm

Hi!

Could anybody help me how is it to extract the grain composition from 'Micress results?

Thanks.
Last edited by Bernd on Mon Sep 16, 2019 9:20 pm, edited 1 time in total.
Reason: Commercial announcements are not allowed in this forum!!

admin
Site Admin
Posts: 56
Joined: Fri Jun 13, 2008 4:03 pm

Re: Discuss

Post by admin » Mon Sep 16, 2019 9:33 pm

Dear 1Tap,

Please note that links are only allowed in this forum, if they are not commercial. For this reason, your signature has been deleted. However, you may link to your private homepage or to where you are affiliated.

Thank you for your understanding!

admin

Bernd
Posts: 1504
Joined: Mon Jun 23, 2008 9:29 pm

Re: Discuss

Post by Bernd » Mon Sep 16, 2019 9:38 pm

Dear 1Tap,

Welcome to the MICRESS Forum!

Unfortunately, it is not straightforward to get the composition per grain from a MICRESS result, if there are more than one grain of the same phase. The reason is that it is not possible to exactly assign the composition at grain boundaries to the corresponding grains.

However, there is an approximate solution which is based on the .korn output and which uses "Operations" in DP_MICRESS. Please tell us in more detail which is exactly the case you want to address.

Best regards
Bernd

Post Reply