Page 1 of 1
Discuss
Posted: Sat Sep 14, 2019 9:20 pm
by 1Tap
Hi!
Could anybody help me how is it to extract the grain composition from 'Micress results?
Thanks.
Re: Discuss
Posted: Mon Sep 16, 2019 9:33 pm
by admin
Dear 1Tap,
Please note that links are only allowed in this forum, if they are not commercial. For this reason, your signature has been deleted. However, you may link to your private homepage or to where you are affiliated.
Thank you for your understanding!
admin
Re: Discuss
Posted: Mon Sep 16, 2019 9:38 pm
by Bernd
Dear 1Tap,
Welcome to the MICRESS Forum!
Unfortunately, it is not straightforward to get the composition per grain from a MICRESS result, if there are more than one grain of the same phase. The reason is that it is not possible to exactly assign the composition at grain boundaries to the corresponding grains.
However, there is an approximate solution which is based on the .korn output and which uses "Operations" in DP_MICRESS. Please tell us in more detail which is exactly the case you want to address.
Best regards
Bernd